On 1/12/26 11:43, andy pugh wrote:
On Mon, 12 Jan 2026 at 15:28, andy pugh <[email protected]> wrote:
When https://github.com/selroc/pycam/actions has finished you may well
be able to grab a set of .deb packages from the "artifacts" area.
I am puzzled why these Actions are still queued.
There are some suggestions on the web on how to fix this.
I agree Andy, The last time I had an endoscope camera that actually
worked (for about a week, then the next apt update broke it again) with
LinuxCNC, all my machines were running jessie. Works fine with cheese
in wheezy, buster, bullseye, maybe in bookworm but my only bookwork
install is on the pi4b that runs my Sheldon, but not in LinuxCNC.
That line in the ini file that starts it, always fails & adds 30+
seconds of failure spew that doesn't tell /me/ what the real error is
while starting LinuxCNC. So it gets commented out. Lots of quite
useful SW has been written to simplify job setup, I have it in in my
axis GUI. Does anyone care? Apparently in the last decade, no.
Cheers, Gene Heskett, CET.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Don't poison our oceans, interdict drugs at the src.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
