I'm still using RTAI for a fast low latency control of a difficult to tune torque mode servo.
On Thu, Feb 19, 2026, 8:49 AM N. Christopher Perry via Emc-users < [email protected]> wrote: > I still use RTAI. > > N. Christopher Perry > > > On Feb 17, 2026, at 5:24 PM, John Dammeyer <[email protected]> > wrote: > > > > > >> > >> From: Eric Keller [mailto:[email protected]] > >>> On Tue, Feb 17, 2026 at 4:12�PM John Dammeyer > >>> <[email protected]> wrote: > >>> > >>> How do I know if I'm using RTAI? > >> > >> uname -a > >> > > > > Thanks. > > On the actual Mill with a PC, PREMPT 2.8.1 > > On the lab bench Pi4, PREMPT 2.8.4 > > > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
