> "Gabriel Massip" <[EMAIL PROTECTED]> wrote:
> I don't figure out how to show the hyperfocal distances on a
> non-push-pull zoom. Probably the most practical form to do it
> would be a little electronic (curved LCD?) display in the lens
> barrel that, for the given aperture, focal distance and focus
> setting, gave the in-focus range.

Hi Gabriel,

Why does this have to be on the lens?  Why not on the camera?
Make the Landscape mode an Automatic Hyperfocal mode. No thinking
required.

If you like thinking and doing instead of just complaining,
perhaps have a look at the DOF chart at the Canon Camera Museum:
http://www.canon.com/camera%2Dmuseum/camera/lens/ef/data/ef%5F28%7E135%5F35is%5Fusm%5Fdof.html

It would seem that there is an approximation to the f/16 DOF already
marked on the lens.  Look at the red NUMBERS of the IR Focussing Index.
Ignore the red lines.  The center of the number is APPROXIMATELY the
DOF mark for the respective focal length.

E.g. Let's find the hyperfocal point for f/16 and 28mm focal length.

Turn the focussing ring so that Infinity is approximately opposite
the red number "28" (which is at the right hand edge of the distance
window). You will find that the lens is focussed near 3 meter, which
is the hyperfocal distance for f/16. At the opposite end of the window
is shown 1 metere, which is the near point for f/16

If you need another aperture, remember that DOF is directly proportional
to aperture. So use half the range for f/8, and a quarter for f/4, etc.

Cheers
Julian Loke
P.S. This sort of undocumented stuff would be good for the EOS
documentation project http://www.eosdoc.com/

*
****
*******
***********************************************************
*  For list instructions, including unsubscribe, see:
*    http://www.a1.nl/phomepag/markerink/eos_list.htm
***********************************************************

Reply via email to