On 27 Jul 02 at 8:53, Darrell Dorsey wrote:

> The tripod socket on my PB-E2 is stripped out.  There are a few thread left.
> Just enough to attach a Kirk QR plate.  But I am afraid I will eventually
> loose them.  I guess I must have cross threaded or over tightened the screw
> at times.
> 
> In any case I order a new socket from Canon.  The problem is I can figure
> out how to get the old one out and the new one in.  I have removed the
> plastic covering plate on the bottom of the PB-E2, but I dont see any other
> screws or attachemets.  Has any one else done this.  If I cant figure it
> out, then I'll have to send the thing to Horizon or Canon.  I just hate
> being with out the booster.

Sounds as if you either haven't already received the new one, *or*
the new one doesn't show any sign either how it is attached? 

I would assume there is a quite beefy method of locking it, otherwise 
lots of people would complain about these sockets turning loose....



--                 
Bye,

Willem-Jan Markerink

      The desire to understand 
is sometimes far less intelligent than
     the inability to understand

<[EMAIL PROTECTED]>
[note: 'a-one' & 'en-el'!]
*
****
*******
***********************************************************
*  For list instructions, including unsubscribe, see:
*    http://www.a1.nl/phomepag/markerink/eos_list.htm
***********************************************************

Reply via email to