----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Thanks Chris. DICK & NANCY [EMAIL PROTECTED] ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Sent: Thursday, April 10, 2003 8:37 PM Subject: Re: [COUPERS-FLYIN] Nose strut fluid gage ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- Here's the address of a drawing of the part in question along with all of the measurements etc. http://65.64.222.169/Erco/Ercoupe-Large/A-159.jpg According to that drawing, the bottom 1/4" of the coil should be marked red.. There should also be a green mark starting 5" from the bottom going up to 5 1/4" making it 1/4" wide also for any of you out there mathematically challenged like me. Oh yes, it also says to use oil resisting paint. Enjoy. Chris http://chris.trent.net On Thu, 10 Apr 2003 18:01:23 -0700, "Richard Eddinger" wrote: ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- My fluid level gage for the nose strut on my 415C/D has no marks on it. The gage itself is 11 in. long where should the mark be for it to have a sufficient amount of hyd. fluid. DICK & NANCY [EMAIL PROTECTED] ========================================================================== == == To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers/ ========================================================================== == == To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers/ ========================================================================== ==== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers/
<<attachment: winmail.dat>>
