Glen, the proper place to put the pipe is thru the hollow axle from the inside. you'll need a 3/4 in steel pipe, black iron or galvanized it doesn't matter. pipe should be about 14 in long, take an angle grinder and grind a 1/4 in slot in the end of the pipe so it will slide in over the 1/4 in bolt that goes thru the axle. take a look it will be obvious. good luck, Larry C, N3452H. --- Glen Davis <[EMAIL PROTECTED]> wrote:
> Gang > > I have seen many Ercoupes jacked up by placing a > steel rod in the hole on the landing gear where the > knee joint is located. Then, once the rod is in > place, lifting it with a floor jack. On my Ercoupe, > there is no hole in the Knee joint on the main gear. > It appear to be filled in with a big bolt. Has > anyone seen this before? > > Glen > > > > Glen Davis > 917 297 1111 > www.ishootpictures.com > www.ercoupepilot.com
