Michael Lum wrote:
I will add AT_SS7PC.
Does anyone have any suggestions for PC formatting ?
From the packet-mtp3.c dissector I will take the following:
ANSI/CHINESE ITU x-y-z where each of x, y and z are 8 bit values.
ITU MTP3 Q.704 does not seem to indicate a format for the PC other than being a 14 bit value. However, I have seen it represented as a-b-c where a and c are 3 bits and b is 8 bits.
Our engineers prefer the 14 or 24 bit decimal value as opposed to any formatting because then there is no ambiguity about the value.
I have also seen:
8.8.8 for 24-bit point codes 3-8-3 for 14-bit
I.e. the '.' versus '-' was supposed to indicate 24 versus 14 bit.
Anybody else have input ?
I have a fairly strong preference for the "8-8-8" for ANSI PC's and a similar--but less strong--preference for Chinese ITU. (In fact I'd like to, at some point, find a way for M3UA to display its point codes like this instead of just decimal.)
I've also contemplated adding a way to display ITU PCs as 3-8-3 so it would be cool if this were available as a preference.
_______________________________________________ Ethereal-dev mailing list [EMAIL PROTECTED] http://www.ethereal.com/mailman/listinfo/ethereal-dev
