Make sure you have --enable-sii-assign when you run ./configure to setup the stack before compilation
On Fri, 2016-10-21 at 14:19 +0200, Philippe Leuba wrote: > Hi, > > I try to use a Beckhoff EL7211-0010 module but encounter the following error: > > EtherCAT ERROR 0-3: Failed to set PREOP state, slave refused state change ( > INIT + ERROR). > EtherCAT ERROR 0-3: AL status message 0x0050: "EEPROM No Access ". > > I have already tried to rewrite the sii with the file exported from TwinCAT, > but without any changes. > > Any ideas? > > Philippe Leuba > _______________________________________________ > etherlab-users mailing list > etherlab-users@etherlab.org > http://lists.etherlab.org/mailman/listinfo/etherlab-users Outbound scan for Spam or Virus by Barracuda at Delta Tau _______________________________________________ etherlab-users mailing list etherlab-users@etherlab.org http://lists.etherlab.org/mailman/listinfo/etherlab-users