Hi folk's,
 
I drilled/tapped 1/4-20 in the middle of the two ARM bolt feed buss bars to 
move the incoming feed into the center of the bar.  On the other two quadrants 
I put a .1 milli-ohm 1/2" OD smashed flat copper water pipe across the two 
brush connections on the Netgain/Warfield" Impulse 9".  Mercen brush co 
recommended also switching to C-4282-X with A121 material, higher current 
voltage rated than the previous material so I ordered a set of those.  They 
said the softer material will evenly seat/current share better and be gentler 
on the comm.  I put the photos of the fix on my www.REEVA.info "project 
gallery" page (scroll to the bottom for most recent project).
 
Have a renewable energy day,
Mark                                      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://lists.evdl.org/private.cgi/ev-evdl.org/attachments/20130529/86433c98/attachment.htm>
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA 
(http://groups.yahoo.com/group/NEDRA)

Reply via email to