RE: A little fine tuning help please...

[Zangara, Jim]

Title: Message

dude - it is the route.   you are not using DNS at this point because telnetted directly to the server.   The server is clueless about what the native domain is so it is considering everything a relay.     Jim Zangara, MCSE+I IT Manager Special Projects Engineer Premiere Radio Networks A Division of Clear Channel Communications 15260 Ventura Blvd Suite 500 Sherman Oaks, CA 91403 Direct: (818) 461-8620 mailto:[EMAIL PROTECTED] I used to own an ant farm but had to give it up. I couldn't find tractors small enough to fit it. -- Steven Wright -----Original Message----- From: Michael Reid [mailto:[EMAIL PROTECTED]] Sent: Wednesday, April 17, 2002 11:41 AM To: MS-Exchange Admin Issues Subject: RE: A little fine tuning help please... Sorry, it's 2K. I've just worked on MX, so I'm going to see how that one fairs. Then I'll do the route thing. One adjustment at a time :]   -----Original Message----- From: Martin Blackstone [mailto:[EMAIL PROTECTED]] Sent: April 17, 2002 2:29 PM To: MS-Exchange Admin Issues Subject: RE: A little fine tuning help please...   I'm sorry. Is this Exch 55 or 2K. Since you didnt say, I will assume you have the same as I do. In the Internet Mail Connector you need to have the domain added under the routing tab. -----Original Message----- From: Michael Reid [mailto:[EMAIL PROTECTED]] Sent: Wednesday, April 17, 2002 10:28 AM To: MS-Exchange Admin Issues Subject: Re: A little fine tuning help please... I'm working the DNS part out with Jeremiah Watson (earlier response). What are you refering to by routing in IMS?   Michael ----- Original Message ----- From: Martin Blackstone To: MS-Exchange Admin Issues Sent: Wednesday, April 17, 2002 3:02 PM Subject: RE: A little fine tuning help please...   Two things. Check your DNS. Also make sure you have added the domain under Routing in the IMS -----Original Message----- From: Michael Reid [mailto:[EMAIL PROTECTED]] Sent: Wednesday, April 17, 2002 9:55 AM To: MS-Exchange Admin Issues Subject: A little fine tuning help please... So this is what I get when I send email to my domain:      ----- The following addresses had permanent fatal errors ----- <[EMAIL PROTECTED]>     (reason: 550 5.7.1 Unable to relay for [EMAIL PROTECTED])      ----- Transcript of session follows ----- ... while talking to scotiazone.com.: >>> RCPT To:<[EMAIL PROTECTED]> <<< 550 5.7.1 Unable to relay for [EMAIL PROTECTED] 550 5.1.1 <[EMAIL PROTECTED]>... User unknown The funny thing is that this is a reply from a  mail I sent out using the mail.scotiazone.com/exchange OWA. It mailed it out fine, when I replied, I get this. Any ideas? The user exists, I logged in through OWA no problem.   Michael List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm List Charter and FAQ at: http://www.sunbelt-software.com/exchange_list_charter.htm