I can get my Lynksys USB100TX to work on my Iopener w/ Mandrake 7.1 but not at
bootup where eth0 is delayed/failed. I believe its a network restart that
actually gets it going (I enter and leave netconf without doing
anything...rc5d/510network reload is the 'change' that is activated). I also
get an error on shutdown, something like: dev_close, bug eth0 still running.
All I did was enter the pegasus module (not one of the menu choices in netconf)
for eth0 when I setup networking in netconf (alias eth0 pegasus was added to
conf.modules). What do I need to do to get eth0 running at bootup?
Following are bootup messages and network restart messages
Bootup:
Jul 17 02:44:43 iop kernel: usb-uhci.c: $Revision: 1.228 $ time 15:46:55 May 10 2000
Jul 17 02:44:43 iop kernel: usb-uhci.c: High bandwidth mode enabled
Jul 17 02:44:43 iop kernel: usb-uhci.c: USB UHCI at I/O 0xe400, IRQ 15
Jul 17 02:44:43 iop kernel: usb-uhci.c: Detected 2 ports
Jul 17 02:44:43 iop kernel: usb.c: new USB bus registered, assigned bus number 1
Jul 17 02:44:43 iop kernel: usb.c: USB new device connect, assigned device number 1
Jul 17 02:44:43 iop kernel: hub.c: USB hub found
Jul 17 02:44:43 iop kernel: hub.c: 2 ports detected
Jul 17 02:44:43 iop kernel: usb-uhci.c: USB UHCI at I/O 0xe800, IRQ 15
Jul 17 02:44:43 iop kernel: usb-uhci.c: Detected 2 ports
Jul 17 02:44:43 iop kernel: usb.c: new USB bus registered, assigned bus number 2
Jul 17 02:44:43 iop kernel: usb.c: USB new device connect, assigned device number 1
Jul 17 02:44:43 iop kernel: hub.c: USB hub found
Jul 17 02:44:43 iop kernel: hub.c: 2 ports detected
Jul 17 02:44:43 iop modprobe: Note: /etc/conf.modules is more recent than
/lib/modules/2.2.15-4mdk/modules.dep
Jul 17 02:44:43 iop usb: Loading USB interface succeeded
Jul 17 02:44:44 iop kernel: usb.c: USB new device connect, assigned device number 2
Jul 17 02:44:44 iop kernel: eth0: Linksys USB100TX
Jul 17 02:44:44 iop kernel: hub.c: already running port 1 disabled by hub (EMI?),
re-enabling...
Jul 17 02:44:44 iop kernel: usb.c: USB disconnect on device 2
Jul 17 02:44:44 iop kernel: usb.c: USB new device connect, assigned device number 2
Network restart:
Jul 17 02:53:02 iop kernel: pegasus.c: party FAIL ffff
Jul 17 02:53:02 iop kernel: pegasus.c: eth0: set Rx mode
Jul 17 02:53:02 iop last message repeated 3 times
Jul 17 02:53:05 iop network: Bringing up device eth0 succeeded
