Hi, I installed mdk 7.2 on a Compaq Proliant 2500 server, that comes with a Compaq Netelligent 10/100 TX network card, the installation process detected it and configured it with no problems, but when I start the server the eth0 device doesn't load, and if I do a /etc/rc.d/init.d/network restart, it apparently restarts but eth0 doesn't come up. Looking in the startup messages I found the following: TLAN: eth0: Error reading MA from eeprom: 1 TLAN: cannot open eth0 because irq 0 already in use What could be? the network card is damaged? why it is using irq 0? thanks. -- --------------------------------- Juan Luis Baptiste M. Pontificia Universidad Javeriana Ingenieria de Sistemas Linux Registered User #119248 http://www.merlinux.org "We're back to the times when men where men and wrote their own drivers" Linus Torvalds. ---------------------------------