On Mon, Aug 26, 2013 at 10:50:55AM -0700, Gerald Stanje wrote: > Hello, > > > > I use VN2VN mode and tried to create the following topology: > > > > eth2.569 (ixgbe) tap0.569------ fcoe target > > | | > > --------------- virbr1--------------- > > > > I attached my script including output and the syslog at the end. > > Why does the call dcbtool fail with this message: Device not found, link > down or DCB not enabled??? > Because the tap0 interface, being a software defined virtual interface has no hardware to enable DCB on.
Neil _______________________________________________ fcoe-devel mailing list [email protected] http://lists.open-fcoe.org/mailman/listinfo/fcoe-devel
