Hi Tim; On Thu, 2008-07-03 at 13:28 +0930, Tim wrote: > On Wed, 2008-07-02 at 10:43 -0400, William Case wrote: > > If it is, how do I remove it (from sdb -- I presume)? > > Extra stuff shouldn't matter, if you configure the first thing to take > over. > > i.e. I can have ten discs in a box, GRUB on all of them. But if the > first thing the BIOS does is read GRUB on the first drive, and that then > loads the next stage properly, it doesn't matter what's on any other > drive. > > Did you do what I suggested, long ago, issuing manual GRUB commands to > set up your system? (i.e. NOT using grub-install script). > No, I haven't yet. I will in the morning. I am not arguing with your suggestion. I, in fact, saved those instructions and went back to the manual to make sure I thoroughly understood what I was doing. I will use them in the morning.
If you remember, except for the double splashimage, my system is booting as it should. Rather than simply getting things to work, the challenge to me over the last couple of days has been to fully understand what has been happening. I have managed to dig into the workings of the mbr, grub stages, video modes much deeper than if I had simply left things as a booting problem to fix. As I have said, I have climbed the grub learning curve in the past. This time I wanted to take an active role in actually undoing something or fixing something. > grub > root (hd..... (where /boot is) > setup (hd.... (where BIOS starts to boot from) > quit (write the changes) > Perhaps I am being just a bit stubborn, but I wanted to learn how to diagnose the problem first, not just write something over top of it. -- Regards Bill; Fedora 9, Gnome 2.22.2 Evo.2.22.2, Emacs 22.2.1 -- fedora-list mailing list fedora-list@redhat.com To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list