I've just discovered the same thing this evening. I am working on a
sizeable webby showing LS40's performance scanning various transparency
films, using Vuescan: single and multi-pass and Nikon Scan.
Jawed
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Mark T.
> Sent: 04 August 2001 07:26
> To: [EMAIL PROTECTED]
> Subject: Re: filmscanners: Vuescan Image vs Slide setting
>
>
> A small cautionary tale.
>
> It appears Vuescan's 'Slide' setting may result in blown out
> highlights, at
> least for my Acer (perhaps it is related to the lack of exposure
> control..?). I would be interested to hear if anyone else has
> experienced
> the following.
>
> A challenging (!) Ektachrome I scanned this morning was showing burnt out
> highlights in a small area. I tried adjusting white and black points,
> image brightness and gamma, and could not improve it. I had just about
> given up and assumed the area was in fact burned out on the
> slide, or that
> maybe the Acer wasn't resolving it. But then I tried Miraphoto,
> and it did
> a better job.. So I went back to Vuescan, and puzzled over what the
> problem was. I changed the Media Type to IMAGE rather than
> SLIDE, and sure
> enough, there was my lost data..
>
> Moral - if your highlights are blown, check that setting!
>
>
>
> If you're interested, I've posted samples here..
>
> http://members.ozemail.com.au/~markthomasz/burnt.htm
>
> Mark T.
>
>
