Hi, Johnny-- The Scanwit slide holder as delivered is hard to load quickly, and it also beats up square-cornered cardboard slide mounts. But the fix is simple. You just need to be careful--for your own sake, not the slide-holder's. The first problem is the curved "keeper" at the top-right corner of each slide window. Cut the radius curve back to where it's about square with the top and right side, using a sturdy utility knife, a very sharp pocket knife, or small wood-chisel (an X-acto #45 short-beveled blade will work OK--but the long, tapered blade is hard to control). This will keep your cardboard mounts from being bent or damaged. The second problem is the dual plastic springs at the lower-left corner. Some people remove *both* springs, but that leaves too much play when the slide is inserted, AFAIC. I remove only the bottom spring, leaving the spring on the left side in place. The springs can either be cut or broken off, but the "stump" should be shaved down so the slide moves over it smoothly. When the slide is pushed against the remaining spring from the right and pressed down, there's a satisfying little "click" when it seats properly. If a person is left-handed, they might prefer to remove the side spring and leave the bottom spring--I doubt if it makes much difference--the idea is to make slides easier to load, yet still fit securely in the holder. A word of caution: *be careful*. Blood on your slides makes them harder to color-correct! ;-) I've made this post a couple times in the past--this time I'm giving it a subject-heading that's hopefully more definitive. :-) Best regards--LRA PS--Thanks again to Ed Hamrick for the original suggestion. Johnny wrote: >Hi Lynn, > >Do you have problems loading slides into your ScanWit or is it just >me? I'd been using mine just for negatives for a few weeks and was >thinking that it was the best thing since sliced bread. Well, maybe not >really that good but I was pretty well satisfied after I tried some 100 ASA >film instead of Portra 400VC. Well, yesterday I got back some mounted >Velvia slides and I really like the quality of the scans but loading the >holder is driving me crazy. I've tried turning the thing in forty eleven >different directions but I haven't found a method that works well. Are >there any secrets that might help with slides other than getting them cut >and sleeved instead of mounted? > >Thanks, >Johnny > >__________________________ >Johnny Johnson >Lilburn, GA >mailto:[EMAIL PROTECTED] > _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
