Paul-- Your post was very sane and reasonable and after reading it I was feeling that maybe life isn't so bad after all... until I turned back to my shiny new, $1,600 Nikon LS-4000ED and returned to wrestling with focus problems. Your final word is a good one so you don't have to respond, but I'd at least like to share my thoughts with the list.
Three years ago I bought a 2,400 dpi Minolta Scan Dual for $500 which was the best I could afford at the time. It scans one of my favorite Kodachrome 64 slides with even sharpness across the entire field, even into the corners, albeit only at 2,400 dpi. Now, three years later, I spend three times as much for a top of the line scanner with two or three generations of improvement. I find that on this favorite slide I can get it sharp in the center and fuzzy in the corners or vice versa. Or, if I set the focus point (numerically) halfway in between then I get maximum sharpness in a ring-shaped region, while the center and corners are BOTH out of focus. Now there's nothing wrong with this in principle, and I wouldn't mind if it was only a little bit out of focus, it's just that (with the focus at the halfway point) the center and corners are no sharper than my three year old scanner is across it's entire field. So it's very disappointing to wait three years and spend three times as much to get no better sharpness across the field than what I've already got (other things are LOTS better, but here I'm concentrating on the focus problem). Now even this wouldn't be so bad if all the other scanners had the same problem. But I've never heard about this as an issue with the Polariod SprintScan 4000, or the Canon FS4000, or higher end scanners such as the Imacon flextites (although there was a recent post by a person who's had this issue with his Artixscan 4000). So here I am with thousands of cardboard mounted Kodachromes, of which perhaps a hundred are worth some serious attention, and I have to think: If I focus near the center and let the edges and corners go so fuzzy that (depending on the slide) they're no better than a 1,000 to 2,400 dpi scanner, is that good enough for images I really care about? Will the fuzziness show on the largest prints I'm likely to make? Am I willing to put up with the incredible hassle of glass mounting a hundred (or hundreds?) of slides? And when I get to my negative strips, will I have to slice the good ones out of the middles and glass mount them too? Would I have avoided this problem entirely had I bought a Polaroid or Canon? I wouldn't mind if the sharpness only varied a little bit across the field. But losing half the resolution of the scanner is highly unsatisfactory, both intellectually and visually. --Bill At 5:23 PM -0700 20-10-01, PAUL GRAHAM wrote: >Hi all, > >My opinion on film flatness has been explained before, so this will be my final word on the topic.... -- ====================================================================== Bill Fernandez * User Interface Architect * Bill Fernandez Design (505) 346-3080 * [EMAIL PROTECTED] * http://billfernandez.com ======================================================================