* Ren? Wuttke ([EMAIL PROTECTED]) [031103 22:01]: > Hi everyone, > > I tried to install gnuplot on Panther with fink 0.6.1 using the command > 'sudo apt-get install gnuplot'. I get the following message: >
I got gnuplot installed on my 10.3/fink-0.6.0 setup tonite. I grabbed my old gnuplot-3.8.xxx.deb, and tried to 'dpkg --install' it; That told me I needed aquaterm and libpdf (?). After I installed those two using fink, I was able to install the gnuplot .deb and run it just fine. I noticed that gnuplot hasn't shown up on the fink list of packages for 10.3/0.6.x yet. After I tried and failed to make the tarball, I remembered I had the .deb on my backup HD. > The following NEW packages will be installed: > aquaterm dlcompat-shlibs gnuplot libjpeg-shlibs libpng3-shlibs > libtiff-shlibs readline-shlibs texinfo xfree86 xfree86-shlibs > 0 packages upgraded, 10 newly installed, 1 to remove and 0 not > upgraded. > Need to get 57.3MB of archives. After unpacking 0B will be used. > > I deny to proceed, because Apple's X11 was installed an i want to use > it. Therefore I think, that I dont need xfree86. > I'm not sure why you are getting these errors --- if your XCode/x11 from Apple is installed OK, the xfree stuffs shouldn't show up. Perhaps if you look at the (recent) messages relating to XFree86 problems and clean up your install? I'm sorry I'm of limited help here. Tchuss -- C. Michael McCallum | "That may be one tough nut to crack, Associate Professor | but I am one determined Chemistry, UOP | little squirrel" [EMAIL PROTECTED] | (209) 946-2636 | fax (209) 946-2607 ------------------------------------------------------- This SF.net email is sponsored by: SF.net Giveback Program. Does SourceForge.net help you be more productive? Does it help you create better code? SHARE THE LOVE, and help us help YOU! Click Here: http://sourceforge.net/donate/ _______________________________________________ Fink-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/fink-users
