Depending on your topology check your firewall /router acls to see if your
allowing snmp in or you have defined the router your trying to monitor on
the ISP end and allow it to send snmp in..
Regards
Bill Lavalette
Chief Security Officer
CyberBase7 Security Services METRO-SOC
Email:[EMAIL PROTECTED]
Web:http://www.cyberbase7.com
Phone:972.782.6595
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of ragu nandan
> Sent: Thursday, January 04, 2001 8:57 PM
> To: [EMAIL PROTECTED]
> Subject: Off the topic: MRTG on NT
>
>
> Hi,
> I am trying to move MRTG from a unix machine to a NT
> box. I install perl, MRTG etc on NT. I run the
> cfgmaker, indexmaker and I am successfull in
> monitoring my internal switches and other WAN routers.
> However I can't monitor any of WAN routers on the
> ISP's end or at my end. In short, I can monitor only
> internal addresses.
> I can ping ISP's router as well as on my side. When I
> run mrtg mrtg.cfg, it complains about SNMP get/walk
> problem (can reproduce the exact error message later).
> I have the right community string too. I have SP4
> installed on the NT machine. Both the NT machine and
> Unix machines are behind the FW.
> Any pointers will be appreciated. Thx
> Ragu
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Photos - Share your holiday photos online!
> http://photos.yahoo.com/
> -
> [To unsubscribe, send mail to [EMAIL PROTECTED] with
> "unsubscribe firewalls" in the body of the message.]
>
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
