You want tot set the port to "monitor". it will only be able to "monitor"
per VLAN.
-----Original Message-----
From: Jeremy Melanson
To: [EMAIL PROTECTED]
Sent: 2/6/01 12:36 PM
Subject: Forwarding all traffic to a port on a Catalyst Switch...
This may be a little off-topic, but I was wondering if anyone can give
me some insight on how to configure a Catalyst 2900xl to forward any
traffic passed through it to a specific port. I'm installing a network
monitor that sniffs the network for any illegal packets, and everyone
knows how well that works on a switched network.
Last I heard, there is a waty to do this, but I can't for the lift of me
figure it out.
Thanks for any input.
--
Jeremy Melanson
Network Support Engineer
jmelanson @softricity.com <mailto:[EMAIL PROTECTED]>
Softricity, Inc.
332 Congress Street
Boston, MA 02210
ph 617.695.0336 x142
fx 617.338.7769
www.softricity.com <http://www.softricity.com/> - Powering Software as
a Service
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
