show flash ?
SAM
-----Original Message-----
From: Grantham, Scott [mailto:[EMAIL PROTECTED]]
Sent: Montag, 25. Juni 2001 18:24
To: '[EMAIL PROTECTED]'
Subject: PIX Upgrade and failover question.
Hello,
We currently have a single PIX 520 running 4.2(3), and I was given the
project to add a failover PIX for redundancy. I found the PIX 520 Failover
Bundle (PIX-520-FO-BUN), and I had a question about what I should do with
our current software version on our PIX. 4.2(3) is very stable for us, but
since the failover requires the 2 boxes to be running the same version, I
was going to upgrade our current PIX to 5.3.1, and this is where I'm getting
a bit confused. Cisco says that releases higher than 5.2.1 require a 16MB
Flash card in the PIX, and to use the 'show version' to determine the amount
of flash mem in the box. Doing a 'show version' on our box only shows the
amount of RAM, and not Flash. How can I determine the amount of Flash in
our current 520?
Thanks,
Scott Grantham
*************************************************************
This email may contain confidential and privileged
material for the sole use of the intended recipient. Any
unauthorized review, use or distribution by others is
strictly prohibited. If you are not the intended recipient
please contact the sender and delete all copies.
*************************************************************
_______________________________________________
Firewalls mailing list
[EMAIL PROTECTED]
http://lists.gnac.net/mailman/listinfo/firewalls
_______________________________________________
Firewalls mailing list
[EMAIL PROTECTED]
http://lists.gnac.net/mailman/listinfo/firewalls
