Some PIX520 have only 2mg of flash (Flash=AT29C040A @ 0x300 message at
bootup) Version 5.2 requires 16mg Flash therefore you will need to upgrade.
You probably also see a message like "obsolete flash card" at boot up when
you tried to run on 5.2 code.
Rich Pitcock
-----Original Message-----
From: Meghna Reddy
To: [EMAIL PROTECTED]
Sent: 6/26/01 1:29 PM
Subject: PIX upgrade from 4.4.4 to 6.0.1- boothelper problem
Hi,
I am trying to upgrade my PIX 520 from 4.4.4 to 6.0.1.
Since it is required that the upgrade be done in a
phased manner, I am trying to upgrade to 5.1.2 to
5.2.3 to 5.3.2 and finally to 6.0.1 as suggested by
the CISCO manual and my CISCO sales partner.
I have successfully upgraded to 5.1.2. While i am
trying to get into the boothelper mode using bh52.bin,
the PIX goes into a reboot loop because of which i am
not able to download the next upgrade flash image onto
the PIX. I dont want to go to my sales partner as a
call would be booked and an amount has to be incurred
by the organisation.
Can anyone suggest why this might be happening ??? Is
there anything that I am missing out ??? Any
suggestion wrt this question will be really helpful as
there is already too much pressure to complete the
upgradation.
REgards.
__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/
_______________________________________________
Firewalls mailing list
[EMAIL PROTECTED]
http://lists.gnac.net/mailman/listinfo/firewalls
_______________________________________________
Firewalls mailing list
[EMAIL PROTECTED]
http://lists.gnac.net/mailman/listinfo/firewalls
