Hmmmm..  I have one of mine doing the EXACT same
thing. .... at about the same time (7/2/00 08:early
PST). won't reset, won't startup, nothing.

Coinicidence?  Hmmmmm.......

May I ask what version of software you were using? 
mine was old, Oh! -  very old: 4.1.0p2.

I'll let you know what sonicwall has to say about
mine.

Ralph Elder 
[EMAIL PROTECTED]

> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]
> Sent: Monday, July 02, 2001 10:20 PM

> Message: 1
> Subject: RE: SonicWall Pro Locked Up
> Date: Mon, 2 Jul 2001 15:06:55 -0400
> From: <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>, <[EMAIL PROTECTED]>
> 
> Unfortunately, it never starts flashing.  I have had
to reset 
> it before,
> and it would the test light would flash after a few
seconds 
> after power
> up.  But I have held the button in for almost 5
minutes with nothing
> happening.
> =20
> I just got a letter back from SonicWall Support and
they seem to be
> under the impression it is a defective unit.
> 
> -----Original Message-----
> From: Z. [mailto:[EMAIL PROTECTED]]=20
> Sent: Monday, July 02, 2001 2:54 PM
> To: Chris Patterson; [EMAIL PROTECTED]
> Subject: Re: SonicWall Pro Locked Up
> Importance: High
> 
> 
> when you do the reset, be sure that you shut it off
and then 
> power it on
> with the reset button held in and KEEP holding it
until the 
> light on the
> front starts to flash. once it's started flashing it
takes 
> just a little
> while before it stops and then you should be good to
go.
> =20
> -Z
> =20
> =20
> 
> ----- Original Message -----=20
> From: [EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]> =20
> To: [EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]> =20
> Sent: Monday, July 02, 2001 11:38 AM
> Subject: SonicWall Pro Locked Up
> 
> 
> I have recently been using a SonicWall Pro as an
additional 
> firewall on
> our corporate network.  Yesterday at some time after
12:57pm, 
> it simply
> locked up.  The Power, Test, and Alarm lights are
all solid.  I have
> tried resetting the device by holding down the reset
switch 
> and powering
> it on, but nothing happens.  I cannot reset the
device and install new
> firmware. =20
> =20
> Does anyone out there use this device?  And if so
are you 
> familiar with
> this happening often?  Is there any way around this,
without having to
> purchase a new one?
> =20
> If not, Then I am simply considering this a 2500.00
Door stop.
> --__--__-

=====
-RALPH-

__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/
_______________________________________________
Firewalls mailing list
[EMAIL PROTECTED]
http://lists.gnac.net/mailman/listinfo/firewalls

Reply via email to