It's hard to tell what you are doing from your description. In general, when you permit a rule to pass traffic between 2 hosts, it does. When you subsequently remove or comment the rule, no new traffic between hosts can be established, but existing connections are grandfathered and do not explicitly terminate at that point. To terminate existing connections, you can get to the command prompt and enter: # netguard -t <hostname or IP> This will explicitly disconnect existing connections to that source or destination.
hope this helps. erik _________________________________________________ Erik Elsasser System Engineering CyberGuard Corporation Northeast Region [EMAIL PROTECTED] www.cyberguard.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Anthony Liberty Sent: Friday, October 05, 2001 12:13 AM To: '[EMAIL PROTECTED]' Subject: how to block connection??? HI. I have configured my computer behind firewall , and has allowed telnet connection to/from it . I test for telnet connection and it is work , when i tried to block/deny connection , and update the rule , the connection is still alive. >Does anyone know how to block connection on cyberguard firewall, if the connection is already permit? thanx --anthony-- _______________________________________________ Firewalls mailing list [EMAIL PROTECTED] http://lists.gnac.net/mailman/listinfo/firewalls _______________________________________________ Firewalls mailing list [EMAIL PROTECTED] http://lists.gnac.net/mailman/listinfo/firewalls
