2012/10/27 Stefan Tauner <[email protected]> > Hello Philipp, > > thanks for sharing. > > On Sat, 27 Oct 2012 15:44:51 +0200 > Philipp Wiesner <[email protected]> wrote: > > > I had to make > > some customizations to ft2232.c add support for this programmer. I had to > > build a cable which connects the JTAG interface with the on-board SF100 > > interface. > > But it is just a plain cable without logic, i presume i.e. there are no > hardware modifications necessary for the TI board nor the iEi > mainboard, right? >
Your assumptions are correct. No hardware modifications were made, I just had to jumper the TI board appropriately (basically disconnecting the MCU from the JTAG port). > > I like to share as much of the knowledge I acquired as possible with the > > community. The least thing I can do is send a patch with my modifications > > for the TI development board. I still need to read the instructions on > how > > to prepare and send patches as I haven't done this in a long time. > > How did you obtain the flashrom source (file archive, subversion, > git...)? Depending on that the way to obtain a usable diff/patch vary a > lot. If you need further help you can also ask us on our IRC channel, > #flashrom on freenode, available also via this website: > http://webchat.freenode.net/?channels=flashrom&uio=d4 > I based my modifications on the last release, but as these are just a few additional lines to the sources, I could easily base those on trunk or any other revision. I'll see how far I can get, I'll be gladly asking for help then. -- > Kind regards/Mit freundlichen Grüßen, Stefan Tauner > Kind regards, Philipp Wiesner
_______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
