On Fri, 19 Apr 2013 00:20:54 +0300 George Ciobanu <[email protected]> wrote:
> Hello, > > It's me again. I had some free time so I decided to disassemble the > notebook and to wire it directly to the arduino, using Simon Inns' > schematic. I didn't desolder the chip. > > I've hit a roadblock, though. I get this message: *Probing for Macronix > MX25L6405(D), 8192 kB: RDID byte 0 parity violation. > probe_spi_rdid_generic: id1 0xff, id2 0xffff* > * > * > I tried patching flashrom with http://patchwork.coreboot.org/patch/3851/, > still with no luck. I am sure the flash model is correct, because I can > read it on the capsule. > > I've attached the logs, with and without the -c option. > > In the hope that a solution will arise, > I thank you again. Hello George, the output of the chip as seen by the arduino toggles a lot between the correct output and all high (or some corrupt bits too). This usually indicates a cabling problem. You should not need any patches additional to what is in our subversion repository's HEAD, just check that the connections are good (better :). -- Kind regards/Mit freundlichen Grüßen, Stefan Tauner _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
