Hello, Your reply did not reach the mailing list. Please use "Reply to all" so that your messages can reach more people than just me.
On Tue, Mar 12, 2019, 09:06 Frei Bjerkestrand <[email protected] wrote: > No I'm pretty sure the 1.8V is connected. Should I try to disassemble the > programmer and the 1.8V converter and assemble it again? > So you are using a 1.8V converter between the programmer and the chip? Regarding the original issue: If you can not change any bytes, I would suspect the flash chip is write-protected. Check its datasheet, it is likely pin 3 is somehow pulled low (write-protect pin is usually active when low). Regards, Angel Pons >
_______________________________________________ flashrom mailing list -- [email protected] To unsubscribe send an email to [email protected]
