Please try out the latest flashrom version, maybe with a Linux LiveCD - it has more parameters which should be all accessible after reading about them at -help.
On Sun, Feb 28, 2021 at 8:13 PM <[email protected]> wrote: > > Hello again. Posted this question in irc, but had to disconnect, thats why i > ask here. I build Urja Rannikko's atmega644 programmer and used it with > flashrom 0.9.9 on windows. If i do not connect a flash chip (only parallel > flash chips here to test) to the programmer i get the messages that bus mode > parallel and spi are on (lpc and hw off). When i connect a SST39VF040 to the > programmer and execute flashrom the parallel mode is changed to off, so only > spi is on. > Can i force the programmer / flashrom to check only for flash chips in > parallel mode (with a parameter e.g.)? > > I did notice, that i had the wrong jumper position set for the flash chip (5V > instead of 3,3V). Is it possible that this is the reason why flashrom > switches to spi? I'm pretty sure that the flash chip is dead now, but i have > two more of this type :). > > Hope someone can help. > _______________________________________________ > flashrom mailing list -- [email protected] > To unsubscribe send an email to [email protected] -- Best regards, Mike Banon Open Source Community Manager of 3mdeb - https://3mdeb.com/ _______________________________________________ flashrom mailing list -- [email protected] To unsubscribe send an email to [email protected]
