The flashing stagnante, waiting many time but nothing More I use atmega2560 on MX25L6473E chips, Please Can you Help me.
flashrom v1.6.0 on Linux 6.12.41+deb13-amd64 (x86_64) flashrom was built with GCC 14.2.0, little endian Command line (8 args): flashrom -r flash.bin -p serprog:dev=/dev/ttyUSB0:2000000 -c MX25L6473E -o out.txt Initializing serprog programmer serprog: connected - attempting to synchronize . serprog: Synchronized serprog: Interface version ok. serprog: Bus support: parallel=off, LPC=off, FWH=off, SPI=on serprog: Maximum write-n length is 1013 serprog: Maximum read-n length is 400384 serprog: Programmer name is "frser-duino" serprog: Serial buffer size is 1020 serprog: operation buffer size is 12 serprog: Output drivers enabled The following protocols are supported: SPI. Probing for Macronix MX25L6473E, 8192 kB: compare_id: id1 0xc2, id2 0x2017 Added layout entry 00000000 - 007fffff named complete flash Found Macronix flash chip "MX25L6473E" (8192 kB, SPI) on serprog. Chip status register is 0x40. Chip status register: Status Register Write Disable (SRWD, SRP, ...) is not set Chip status register: Bit 6 is set Chip status register: Block Protect 3 (BP3) is not set Chip status register: Block Protect 2 (BP2) is not set Chip status register: Block Protect 1 (BP1) is not set Chip status register: Block Protect 0 (BP0) is not set Chip status register: Write Enable Latch (WEL) is not set Chip status register: Write In Progress (WIP/BUSY) is not set This chip may contain one-time programmable memory. flashrom cannot read and may never be able to write it, hence it may not be able to completely clone the contents of this chip (see man page for details). === This flash part has status UNTESTED for operations: WP The test status of this chip may have been updated in the latest development version of flashrom. If you are running the latest development version, please email a report to [email protected] if any of the above operations work correctly for you with this flash chip. Please include the flashrom log file for all operations you tested (see the man page for details), and mention which mainboard or programmer you tested in the subject line. You can also try to follow the instructions here: https://www.flashrom.org/contrib_howtos/how_to_mark_chip_tested.html Thanks for your help! Skipping writeprotect-based unlocking for read/verify operations. Block protection is disabled. Reading flash... read_flash: region (00000000..0x7fffff) is readable, reading range (00000000..0x7fffff).
[email protected]
_______________________________________________ flashrom mailing list -- [email protected] To unsubscribe send an email to [email protected]
