I discovered that if I load PowerSDR, start it, set the frequency and then
stop it, I can start Linrad. However, if I then try to start PowerSDR again
it gives me the message "Invalid Sample Rate." Everything is set to 96K at
this point, so I suspect that the message is incorrect. Does Windows 7 have
some new "feature" that doesn't allow multiple apps to connect to the same
audio input source?
73,
Clay W7CE
----- Original Message -----
From: "Clay W7CE" <[email protected]>
To: <[email protected]>
Sent: Friday, February 05, 2010 12:36 PM
Subject: [FlexEdge] Linrad/5000A/Windows 7
Has anyone been successful getting Linrad to talk to the 5000A on Windows
7. Everything works fine on XP. When I try to connect to the Flex Audio
from Linrad I get the following error message:
[1227]Failed to open Rx A/D input from soundcard.
Unknown error code.
I'm running the latest Flex release software on both operating systems:
Power SDR 1.18.3, Firewire Driver 3.5.0.7171, and Firmware 1.3.0.8.
73,
Clay W7CE
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using alpha and beta versions of the software.
