Looks like I'll do without untill Flex sends me the correct board
Ed
At 05:08 PM 10/22/2010, Tim Ellison wrote:
Ed,
If you had a 34B installed, PowerSDR still thinks you have a 34B and
its RF signal path control is different from the 27B. There is a
utility that can update the firmware in your radio to tell it you
are upgrading from 27 to 34 board, but I do not know of any utility
to downgrade. You need to contact Dudley ASAP to see if there is a
way to down grade or expedite the delivery of the correct HRFIO board.
-Tim
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Ed Stallman
Sent: Friday, October 22, 2010 5:46 PM
To: [email protected]
Subject: [FlexEdge] RFIO Board
Changing from RFIO 34B to RFIO 27B do I need to do a firmware update
? yes I had a 34B and that went bad , ordered a new 34B but was sent
a 27B ... I installed the 27B to get going but in setup / general
it show's I have the 34B and I have no receive. help please
Ed
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It
is used for posting topics related to SDR software development and
experimentalist who are using beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
