Yes there was the exclamation mark on one of the USB Audio Device.
How do you handle the 5K and the 3K - use the same database? Don On 11/9/2010 3:43 PM, Tim Ellison wrote:
See my comments below -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Don Sachnoff Sent: Tuesday, November 09, 2010 4:28 PM To: [email protected] Subject: [FlexEdge] Announcing PowerSDR(TM) public beta release, v2.0.16 I installed the latest version on my 1500 without issue and the 1500 is working just fine, however, when I powered up the 3K or the 5K and checked the status I was given the following message "No Devices Found" which indicates the firewire is not working now. [Tim] Yes, that is the case. When you installed PowerSDR v2.0.16 did the installer install a Firewire driver? If so the driver may not have installed properly. With PowerSDR off and all but one FLEX-x000 connected and powered up, look in the Windows Device Manager. Open up the Sound Devices. DO you see the FLEX with an exclamation mark indicating a failed driver install? If so you need to do a manual driver install. I can provide the steps if this is the case. Strange, the last time I used either the 3K or 5K I had no issues. I tired searching the KB but obviously I am not putting in the correct words to search on. Any thoughts? [Tim] Usually beta software doesn't get articles in the KB; only production software. And the release just came out last night too :-) Second question. Is there documentation where the new files are stored for v 2,0,16? [Tim] %APPDATA%\FlexRadio Systems\PowerSDR v2.0.16 If I want to switch between the 5K and the 3K should I setup separate folders or is that not an issue? [Tim] Separate folders are not necessary. But you cannot have both radios powered u p and connected to the same PC at the same time. Don - kx9q _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
_______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
