PROBLEM: "HIGH SWR" displays in the panadaptor panel with tx when no
actual high swr
condition exists.
Condition occurs ONLY when "Enable X2 TR sequencing" is enabled
(Setup - General -
Options).
X2 TR is used to switch amplifier or other devices into TX mode, so
might not be noticed normally by
barefoot users, but anybody should be able to verify the problem.
To observe problem, using above hardware/software, enable X2 TR Sequencing per
above setup panel sequence and click on TUNE. High SWR condition is indicated.
Disable X2 TR sequencing and click on TUNE - problem goes away.
Problem does not occur at all with PowerSDR 1.18.6
My configuration: SDR-1000 with PA, PowerSDR 2.0.16 Beta, XP 32 bit
Media Center Edition
with SP3 in eMachines T5216 computer, Delta-44 sound card and Flex supplied
parallel cable.
Please post your results here.
Jerry W4UK
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
