VERY, SERIOUS good!!!!!
You caught me in a power supply swap interval (I was doing "burn-in" on the club repeater supply) so I didn't get to try it out until this morning. Since I have been using 2.0.16 with no real problems beyond un-implemented feechers, I went against my better judgment and installed 2.0.19 without un-installing 2.0.16 per the release notes etc. and began to use it in a rather un-eventful manner! This is good! I have not been using rcvr 2 much at all so I did note the image test shows a problem on 60m, but I consider this as probably totally un-related to 2.0.19. As to the 1394 drivers. The M$ and the TI have always taken one core to 100% whenever the F5k is powered up and this did not change here. The legacy driver was much better but it seems to have dropped its CPU usage a bit more but I don't have quantitative data unless needed!. Actually, I can't tell the difference between the M$s and the TI driver!. Noise reduction looks good. First time I have seen it work since the demo mode before I bought my sdr1k. I may or may not like the "click tune" change on digi but study will make a difference. The new skin is great. 2.0.16 will be un-installed shortly. Wish list (very non-critical!): Make expert settings sticky. As noted elsewhere, make the simple stuff so it can be safely re-loaded by the nice little utility. Good show! See you at Dayton. Jim McLester W4YXU _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
