Sounds like the install went fine. This is essentially beta software (an RC version), so please submit the behavior in the bug tracker for further investigation. http://kc.flexradio.com/KnowledgebaseArticle50133.aspx
-Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jerry Coufal Sent: Wednesday, May 18, 2011 12:42 AM To: [email protected] Subject: [FlexEdge] Audio Output When RX1 Mode is Set for CWL or CWU I am running a Flex-5000: 2110-2899 with RC1 v2.1.0 (upgraded from v2.0.22) I have dual receivers. When CWL or CWU is selected on any band on RX1, I have no audio output on either RX1 or RX2. If any other mode is selected on RX1 the audio works fine on both receivers. As long as the mode selection for RX1 is selected for anything but CWL or CWU, RX2 audio is good on all modes for RX2 including CWL & CWU. Is this associated with the v2.1.0 RC1? Did something go wrong on the v2.1.0 install? The installation appeared to be flawless - no error messages or other problems during the installation that I could detect. I did not import the database from the previous v2.0.22. I manually re-entered all of the setup configurations. Thanks very much Jerry (WB0DEK) _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
