Hello, I cannot say for sure, but I had the same issue with a Flex3000 in my truck. It seemed I could not figure out where it was coming from for the life of me.
I took out a WiFi card, replace several Fire-wire cards, temporary took out any USB cards. I went into device manager and tried to turn things off, and tried to see what was running at the same time on the same IRQ as the fire wire. It drove me nuts! Then I did something stupid, but for good luck of a reason! I was messing with some wires under the seat and I had loosened a wire from my preamp that amplifies the sound from the 3K to the truck speakers. I turned on the 3k and discovered I had no sound. I was thinking "Great, now what"! But I noticed the pan adapter had settled down like normal as it should. I was like what? It can't be? I found the wire that came off the receive amplifier and place it back on. I had the sound to the speakers again, but there was that signal in the pan adapter. And again it followed me as I went up and down the band. So you see, it was the amplifier and not the 3k! By moving the 3k farther away from the amplifier it helped take it out, but it was still there but it was hard to see on the pan adapter. I still need to replace the amplifier! Search the shack by turning off everything and use a tempoary 12 volt battery to run the flex until you find the issue. At lease I hope you will find the issue this way! K3YI ________________________________ From: Erik Jakobsen <[email protected]> To: [email protected] Sent: Mon, June 27, 2011 2:39:05 AM Subject: Re: [FlexEdge] What is this ? On 6/27/2011 8:09 AM, Erik Jakobsen wrote: > >> Hi. >> >> I have observed, that my Flex 5000A has a "funny" lookout in the >> Panadapter. >> >> It is 'nice' visible if I have no antenna on the F5000A. >> >> But it can be viewed also with antenna connected. >> >> I tried to get rid of it by switching off my Broadband equipment. >> >> It was the router, an accesspoint and a switch. >> >> It had no positive effect on it. >> >> What is it, that I see? >> >> http://www.urbakken.dk/My_F5KA.jpg >> >> 73s >> Erik OZ4KK > > Hi again. > > I have further infomations. > > This time I have made a new screenshot of the phenomenia: > > http://www.urbakken.dk/new.jpg > > And the audio being heard from the noise: > > http://www.urbakken.dk/SDRQuickAudio.wav > > Hope this gives more information. > > 73s > Erik OZ4KK > > > Sorry for the replying by myself :-) I viewed, that the issue always is left to the center mark of the Panadapter. That means, it is there even if I move qrg. http://www.urbakken.dk/issue.avi OZ4KK _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
