Don, In PowerSDR:
Setup->DSP->Keyer->Connections->Secondary. assign the Secondary to the virtual serial port assingment for the keying out of Comcat , or other cw keying program such DX-labs WinWarber or contest programs. John N3WT ----- Original Message ----- From: Don <[email protected]> To: [email protected], [FlexEdge] <[email protected]> Sent: Mon, 05 Dec 2011 19:30:53 -0000 (UTC) Subject: Re: [FlexEdge] Fw: Flex 3000 and CommCat John That’s a new one on me Secondary CW port? Don From:[email protected] Sent: Monday, December 05, 2011 11:05 AM To:Don Cc:[FlexEdge] ; Ted Leonard Subject: Re: [FlexEdge] Fw: Flex 3000 and CommCat Why not just use the secondary CW port selection and then operate CW using virtual serial port assignments? No external cables or keying circuit needed. John N3WT ----- Original Message ----- From: Don <[email protected]> To: [FlexEdge] <[email protected]>, Ted Leonard <[email protected]> Sent: Mon, 05 Dec 2011 18:49:24 -0000 (UTC) Subject: Re: [FlexEdge] Fw: Flex 3000 and CommCat Ted Wait a minute PTT it not normally used between CommCat and PowerSDR. If you are trying to use the keyer in CommCat you will need to make a cable up to key your keyer on the F3K. Usually the cable hooks up to the serial or parallel port on the computer. If you look under the “keyer” section of the manual there are a couple of keying circuits you can build. I still plan on doing a write up for it. But if you have any other questions I will try and help. Don, kd6hq _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
