George, The XVTR output will receive and transmit 0 dBm from 30 KHz to 77 MHz. The PA will not cover below 1.8 MHz. In case you don't know it is a technical challenge just to get a PA output transformer to work well from 160-6m, much less to cover 2200m to 4m. Even though the transistors can cover the range, the PA transformers don't exist at these power levels.
If you want to cover bands other than 160-6m with higher power, you will have to provide your own PA. Other than that, it covers all current and future bands from 30 KHz to 77 MHz at 0 dBm right out of the box. 73, Gerald Gerald Youngblood, K5SDR President and CEO FlexRadio Systems(TM) Email: [email protected] Web: www.flexradio.com <http://www.flex-radio.com/> Tune In Excitement (TM) PowerSDR(TM) is a trademark of FlexRadio Systems On Fri, May 25, 2012 at 10:52 AM, George Allen <[email protected]>wrote: > > The specs give a 300KC (.3Mhz) lower limit. > > I seem to remember a post from Flex stating that the lower limit is 30Khz, > (.03Mhz), Did I remember correctly? > > The specs state that the lower transmit band is 160Mtrs. If the new LF > bands materialize, can the software/firmware be changed so that the 6000 > will transmit on the new LF bands? > > George > K2CM > > > > _______________________________________________ > Flexedge mailing list > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz > This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is > used for posting topics related to SDR software development and > experimentalist who are using beta versions of the software. > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
