Some more questions on transverter operation as part of a repeater site: The specifications state the TX FM is 5Khz; will a slice RX handle 16KF3 without distortion?
Can a slice transmit to the transverter IF port with an offset while concurrently receiving? Will a panadapter on this slice show the transmit signal as 0dbm? Can multiple slice receivers "transmit" on the transverter port? Can two SCUs be assigned to the transverter port? Can a slice be set to recognize a low frequency tone to break the squelch? And related, would this still happen when the audio low frequency limit is set above the tone frequency? i.e. support repeater tone squelch This comes around to using a 6000 as a multiple repeater RX (50 144 220 and 440 concurrently) and optionally using a 6000 to also perform transmit duty by inserting one or more 0dbm signals on the transverter port while concurrently receiving. (The VHF/UHF transmitters would require selective band pass filters to recognize the presence of a transmit signal and cavities to share the same antenna) An alternate configuration is to use the 6000 (even 6700R) in receive only and use the resulting audio (directed to a virtual port) to trigger the repeater transmitter side (crystal controlled TX frequency in the transmitter). _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics.
