I am using WSJT-X r3243 in conjunction JT-Alert-X 2.2.2 and DXLabs with
my Flex-5000. My PTT works just fine. I am not using the CAT interface
built into WSJT-X.
PTT is COM9 RTS in WSJT-X and COM10 RTS in PowerSDR CAT PTT Control setting.
I have the CAT port set to None in WSJT-X and Enable CAT is unchecked.
I use DX Commander memory in DXLab to select the JT9 frequency. I then
have to remember to select the correct frequency in WSJT-X to match my
Flex-5000 frequency. Otherwise the spotting and logging frequencies will
be incorrect. I use the defined drop down frequencies in WSJT-X.
I use vspMgr for my virtual port connection between DXLab and the
Flex-5000. vspMgr does not allow for a three device CAT connection.
It has occurred to me that perhaps DDUtil might allow the use of the
WSJT-X CAT control concurrently with DXLab commander, but I do not have
DDUtil installed and have not tried it. If anyone has had success with
DDUtil using WSJT-X and DXLab Commander let us know.
JT65-HF has a DXLab Commander interface that works fine with my setup.
This does not exist in WSJT-X.
I have had no problems with the VAC interface.
73,
Bill
NJ1H
On 5/1/2013 2:34 AM, Ernest Garcia wrote:
I searched the Flex radio
mail archive and found only one question from NJ1H
listed and there were no response.
JT9 software has only listed
the Flex 1000 on their configuration list. However I am NOT able to get the PTT
or the CAT control to handshake with JT9.
Is there anyone presently using JT9 with the Flex 5000 or 3000?
73, Ernest - W4EG
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software innovation and other technical SDR
topics.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software innovation and other technical SDR
topics.
