Greg, Adding to Jose's post, the installation instructions for using the SDR-1000 with third party softwared can be found at www.hamsdr.com/dnld.aspx?id=31 or at my website http://btracy.com/sdr1k. The document is in pdf format and is titled "Third Party Installation". So far, HRD is the only program specifically rewritten for use with the SDR-1000. Almost all others will work using one of the Kenwood emulations. You can choose the emulation to use on the Setup|CAT Control tab of the PowerSDR software. Pick the one that runs the fastest with your software but not the SDR-1000 emulation unless you are running HRD.
I have not specifically tested the CAT code with Logic 7. 73, Bob K5KDN -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of ab7r Sent: Saturday, September 03, 2005 10:58 AM To: Flexradio@flex-radio.biz Subject: [Flexradio] A couple questions from a new--old--SDR1K user Ordered a new SDR today and wondering if someone could provide some additional info. I understand there is a virtual com port feature now that can be used to link with various logging programs. But most logging programs I have seen do not have the SDR1K as an option. Does it work as some other protocol....i.e....Kenwood? I recall Elecraft works when selecting Kenwood and wondering if it is the same with the SDR. My logging system is Logic 7. 2nd question.... Has anyone interfaced the control box for a SteppIR yagi or vertical with the SDR through the virtual COM port or by some other means? And does this require use of a native COM port and can a USB/Serial converter be used? Looking forward to the new radio....again..hihi. 73 and thanks Greg - AB7R _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz