I got my new SDR-1000 last monday and after setting it up I could work right
away. I am using a M-Audio Delta 44 card.
The only problem was in calibration mode of the PA on 10m where it could not
reach power and the process was terminated with error message. I put in the
values delivered from factory therefore.
Since the day after I found following strange behaviour:
In receiving I have a rather high background noise (-110 dB or about S5)
with a lot of carriers to S9. When I go on transmit I can see and hear the
modulation, but there is no power output and a relay is clicking once. After
going to receive again the receiver is dead - no background noise (-150dB)
and no received signals. I have to go to standby and switch on again to have
the same high background noise. I did a second install of the software
(V1.6.1) but no change.
Any idea what to do?
73's Gerhard OE3GBB
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/attachments/20060518/75397cbf/attachment.html
_______________________________________________
FlexRadio mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archive Link: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/
FlexRadio Homepage: http://www.flex-radio.com
