Jim, are you testing into a dummy load? If you take the top cover off, do you see the LEDs on the tuner blink?
The tuner manual is the Z-100 Operations Manual from the Flex-Radio web site. I'm guessing that the ATU is communicating with the SDR-1000, because if it isn't, PowerSDR has a pop up error message. You can also get the manual on the LDG web site (Z-100) < http://www.ldgelectronics.com/manuals.html > The red and green LEDs tell the status and SWR. I tried using a couple of glass fibers out the gap between the front panel and top cover, but too small for enough light. I will try some big plastic fibers. You can see the LEDs through the fan. --------------------------------------- For me, I think the ATU sometimes remembers what it was tuned for, even though I am in Bypass. I use the ATU on a reactive load and it tunes for that. Then I select Bypass and switch to a dummy load. The SWR is high until I tune in Full for the dummy load. Does anyone else have this too? Mike - AA8K Jim, W4ATK wrote: > I have the SDR-1000 configured with the 100W amp and tuner. With the tuner > in Byp mode, click TUN, Pwr Out indicates 12W. With tuner in Full mode, > click TUN, Pwr Out = 0 Watts. Something is amiss here. > > Jim, W4ATK > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com