Setup-> General->Hardware Config- On that page there is a XVTR TR sense. Swap it.
Bob Al wrote: > I have an SDR that has the DEMI xvtr installed.. While trying to check > the sensitivity of the transverter I discovered that the transverter in > in XMT mode when it should be in RCV and in RCV mode when the consloe > says transmit... > > It appears that is XR/TX control signal from the RFE board is inverted > (i.e. 5v in receive mode ).. > > Is this a software / setup problem ?? or a hardware problem on the RFE ?? > > AL, K0VM > > _______________________________________________ > FlexRadio mailing list > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Homepage: http://www.flex-radio.com > > -- AMSAT VP Engineering. Member: ARRL, AMSAT-DL, TAPR, Packrats, NJQRP/AMQRP, QRP ARCI, QCWA, FRC. ARRL SDR Wrk Grp Chairman "You see, wire telegraph is a kind of a very, very long cat. You pull his tail in New York and his head is meowing in Los Angeles. Do you understand this? And radio operates exactly the same way: you send signals here, they receive them there. The only difference is that there is no cat." - Einstein _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com
