Two of us are experiencing an identical interface anomaly with the above mentioned products. Hopefully someone on one of these reflectors can offer some constructive advice as to the resolution.
We are using WL 10.61E and PowerSDR v1.6.3 and v1.9.0 The systems are set for VHF and UHF bands 50-10368MHz Comport offset is zero PowerSDR is set to the actual frequency using the XVTR screen If you select the band/frequency from PowerSDR, WL follows just fine If you set the frequency from WL PowerSDR follows fine up to the 903 band Above 903, if you select a band from WL the frequency on WL momentarily shows the new band, but after about a second reverts back to 903. Has anyone seen this, or can offer a suggestion? In addition, it is impossible to select 10368 or 24192 from Writelog. Writelog responds with 1036 or 2419 bands instead. This is not good. Any ideas? Thanks Phil K3TUF _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com/ FlexRadio Knowledge Base: http://kb.flex-radio.com/