That oscillator is utterly spectacular. Have a good time with it!
Bob N4HY Mike Monnier wrote: > Hello, > > I picked up a Brandywine GPS4 time and frequency standard that I hope to use > with my SDR 1000. I would like you to look at the phase noise specifications > and tell me if this item is usable as a master oscillator for the rig or a > calibration tool only. > > Frequency 10 MHz > Period 100 ns > Waveform Sinusoid (standard) or square (link selectable) > Drive level 1Vrms (minimum) into 50 ohm load > Phase Noise 100 Hz -140 dBc/Hz > 1000 Hz -150 dBc/Hz > 10 KHz -155 dBc/Hz > Long Term Accuracy 5X10 -12th after 24 hour satellite lock > > I have to reduce the 13 dBm minimum output. I'm looking for a 3-5 dB > attenuator. Thanks for looking. > > Mike Monnier > W8BAC > > > _______________________________________________ > FlexRadio mailing list > [EMAIL PROTECTED] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Knowledge Base: http://kb.flex-radio.com/ > FlexRadio Homepage: http://www.flex-radio.com/ > > -- Robert W. McGwier, Ph.D. Center for Communications Research 805 Bunn Drive Princeton, NJ 08540 (609)-924-4600 (sig required by employer) _______________________________________________ FlexRadio mailing list [EMAIL PROTECTED] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
