Yes. Are you using the flat ribbon type SATA drive cables? If so, you will need to get the more expensive shielded ones.
-Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gerald Capodieci Sent: Tuesday, May 01, 2007 10:48 AM To: [email protected] Subject: [Flexradio] SATA Drive Cable Causes Noise in RX and TX Everything worked fine with my Pentium 4/Intel 2.8 MHz main-board using a ultra ATA/100 Seagate internal drive and a Delta 44. I added a SATA II Maxtor/300 and the noise began. The noise sounds like ignition noise by a near by engine idling. When I disconnect the SATA cable from the main-board the noise stops. Noise is present even with power to the SATA drive is disconnected. NB surpression has no effect. Has anyone solved this one? -------------- next part -------------- An HTML attachment was scrubbed... URL: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/attachment s/20070501/5b0e5c71/attachment.html _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
