Thanks Bill, really appreciate your note. What did you use for the comparator? 73 Neal Campbell K3NC [EMAIL PROTECTED]
telnet to our DX Spotting clusters at: dxc.k3nc.com, ports 12001 and 23 "Devoted to Dogs: How to be your dog's best owner" Great Dog Book at www.abrohamneal.com On Jun 2, 2007, at 7:18 PM, Bill Tracey wrote: > I have one of these little 4 output boards from AADE - have not > used it with an SDR 1000. I have used it with Janus/Ozy -- it > needs a little external comparator circuit to beef up the signal -- > the board on its own only puts out a few hundred mV's peek to peek > -- I needed to bump that op to 3Vpp or so for use with Janus. > > Regards, > > Bill (kd5tfd) > > At 12:21 PM 6/2/2007, Neal Campbell K3NC wrote: >> A couple of years ago I bought a freq standard board from Almost All >> Digital Electronics and it was very reasonable. It has (if m my >> feeble mind remembers correctly) 4 freq BNC outputs, the highest >> being 10Mhz. He tweaks them before sending out. >> >> Has anyone tried this board? Could it play well as a standard for the >> Ozy/Janus combo (since I have Alan's 40Mhz board already in my >> SDR1K)? >> >> Neal Campbell K3NC >> [EMAIL PROTECTED] >> <...snip....> > > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
