This one shows the RF insides that I did not capture at Dayton: http://www.qrpradio.com/pub/Ham/Dayton2007/2848x2132/00071.jpg
Every major RF stage in the exciter and receiver is in it own shielded box. The amplifier is on the other side of the heat sink and is a very multilayer board with large ground plane, etc. Bob N4HY Alan NV8A wrote: > On 07/03/07 01:27 pm elan paim wrote: > > >> why we can't see any nice picture of the inside construction of the 5000a? >> since you only waiting for the cover . >> many thanks . >> p.s >> see if you can post some nice picture from the inside . >> > > http://www.qrpradio.com/pub/Ham/Dayton2007/ > > No, I wasn't the one who took them, > > 73 > > Alan NV8A > > _______________________________________________ > FlexRadio mailing list > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Knowledge Base: http://kb.flex-radio.com/ > FlexRadio Homepage: http://www.flex-radio.com/ > > -- Robert W. McGwier, Ph.D. Center for Communications Research 805 Bunn Drive Princeton, NJ 08540 (609)-924-4600 (sig required by employer) _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/