Am I reading this right? It looks like the Flex-5000 does not need to use a sequencer to have a 6 metre preamp in line. So I could have my 6 metre antenna connected to one antenna port (lets say ANT 1) and my HF antenna to ANT 2. Then I could have a non rf-switched preamp (lets say a DEMI 6MLNA) looped through RX-1 & RX-2 for receiving 6 metres on ANT 1. And no external switching is required for transmitting to keep the RF amp from destroying the pre-amp? http://kb.flex-radio.com/article.aspx?id=10400 RX Antenna Loop Configuration (RX1 IN & RX1 OUT) One of the interesting features of the FLEX-5000 is the Receive only loop. You can configure PowerSDR to take the RX signal from ANT1 (SO-239) and route it to the RX1 OUT BNC connector and back in to the transceiver using RX1 IN. This will allow you to easily place receive only devices in-line to the RX signal chain. Examples of such devices would be a 6m pre-amplifier for weak signal work, a preselector for attenuating strong out-of-band signal sources, or a “wavetrap” for specific frequency interference nulling. 73 Zack N8FNR -------------- next part -------------- An HTML attachment was scrubbed... URL: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/attachments/20070722/cadcc0e0/attachment.html
_______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
